Fluke 5720A service manual Rear Panel Assembly Access

Maintenance 4

Access Procedures

REMOVE

Figure 4-2. Rear Panel Removal

4-10. Rear Panel Assembly Access

Refer to Figure 4-3 during the following procedure:

REMOVE

1

1

11

REMOVE

1REMOVE FACK SCREWS TO SEPARATE THE REAR PANEL CIRCUIT BOARD FROM THE METAL HOUSING.

F4-3.EPS

Figure 4-3. Rear Panel Assembly Access

1.Remove the six securing screws for the Rear Panel assembly housing.

2.Gently pull the rear panel housing from the Rear Panel.

3.Allow the rear panel housing to lay flat on the work surface by removing the two ribbon cables from the Rear Panel board.

4.Remove the two nuts at TB1 and TB2 on the paddle board; separate the associated wires from the paddle board.

4-5