Freescale Semiconductor MPC5200B - page 522

PSC Registers—MBAR + 0x2000, 0x2200, 0x2400, 0x2600, 0x2800, 0x2C00
MPC5200B Users Guide, Rev. 1
Freescale Semiconductor 15-11
NOTE
The FIFO related status bits ORERR, URERR, RxRDY, FFUL and TxRDY will be changed only if
the peripheral (transmitter or receiver) access the FIFO. These bits reflect to the related bits in the
ISR, therefore only the peripheral side can generate a FIFO access interrupt. The bits in the RFSTAT
or TFSTAT register are also set. If the CPU side read from an empty FIFO or write to a full FIFO the
status bits in the RFSTAT or TFSTAT register will be set, but the status bit in the SR register are
unchanged. An access from the CPU side to the FIFO can’t generate an interrupt.
8CDE
DEOF
UART—DCD Error
0 = The DCD input is negated while receiving data.
1 = No error
MIR / FIR—Detect End of Frame
0 = Rx did not receive an EOF after the last read SR command.
1 = Rx received the EOF in the frame. In this case, the interrupt and request can be asserted
even if the Rx FIFO number is less than the threshold and MR1[1]=1.
other Modes—Reserved
9 Error Error Status Detect
0 = The PSC controller detect no errors
1 = The PSC controller detect an error state. This error is a combination of the error bits: RB,
FE, PE, URERR, ORERR from this register and RX and RX FIFO bit from the TFSTAT and
RFSTAT register.
other Modes—Reserved
10:11 — Reserved
12 CMD_SEND Enhanced AC97 Mode—Command Send ready
0 = The data in the AC97CMD register was sent out by the AC97 transmitter
1= The data in the AC97CMD register was not sent out. A write access to the AC97CMD
register set this bit to one. If the AC97 transmitter send out the CMD data then this bit was
cleared.
other Modes—Reserved
13 DATA_OVR Enhanced AC97 Mode— Receive Status Data Overwrite
0 = No received status data overwrite.
1 = The received frame contains a new valid data status word in slot2, but the previous
received status data word was not read out before the new one was written to the AC97Data
register. Therefore the old status data word was lost. A read access to the AC97Data register
cleared this bit
other Modes—Reserved
14 DATA_VALID Enhanced AC97 Mode—Received Status Data
0 = The received frame doesn’t contains valid status data.
1 = The received frame contains a valid data status word in slot2. The received data are
located in the AC97Data register. A read access to the AC97Data register cleared this bit.
other Modes—Reserved
15 UNEX_RX_
SLOT
Enhanced AC97 Mode—Unexpected Receive Slots detect
0 = The received frame contains only the slots which are defined in the AC97Slo ts register or
a frame without AC97 data (frame is empty or contains only slot1 or slot2 data)
1 = The AC97 receive detect one or more slots which are not defined in the AC97Slots
register.
other Modes—Reserved
Bit Name Description