Fuji Bikes 5000G11S/P11S instruction manual Basic Connection Diagram Sink Logic

Basic Connection Diagram (Sink Logic)

G11S:15HP and above	G11S:Up to 10HP
P11S:20HP and above
	P11S:Up to 15HP
		DB)
			(CM)
			(THR)

Ground-fault

circuit interrupter

(GFCI)

RS-485

Fig.2-3-1

Note: The control circuit common terminals [11], (CM) and <CMY> are isolated

(*1) Use a drive with rated voltage matching the power supply voltage.

(*2) Use as required.

(*3) Use this peripheral device when necessary.

(*4) Remove the jumper wire (*4) between P1 and P(+) before connecting a DC REACTOR.

(*5) Be sure to use the braking unit (option)(*6) when connecting the external braking resistor (option)(*5)

(*6) Connect the braking unit to P(+) ans N(-). The auxiliary terminals [1] and [2] have polarity. Connect them as shown in the figure above.

(*7) The drive can be operated without connecting the auxiliary control power supply.

(*8) Terminal (X1) to (X9) can be set to 9 (THR) - Braking unit thermal trip input.

(*9) If usingV2 or C1, as a reference signal, they must be used exclusively.

(*10) It is possible to input voltage signals (0 to +10 VDC or 0 to +5 VDC) to terminals [12] [11] instead of the potentiometer.

2-4