Fuji Bikes 5000G11S/P11S F15 Frequency limiter High F16 Low, F18Bias frequency, F17Gain

F15	Frequency limiter	(High)
F16	Frequency limiter	(Low)

‹This function sets the upper and lower limits for the setting frequency .

F18Bias frequency

‹This function adds a bias frequency to the set frequency value to analog input.

F 1 8 F R E Q B I A S

F	1	5	H	L	I	M	I	T	E	R
F	1	6	L	L	I	M	I	T	E	R

Setting range G11S: 0 to 400Hz
P11S:	0 to 120Hz
Set frequency
+ Maximum frequency
Upper limit value
-100%	Lower limit value
	Lower limit value
Upper limit value	+100%
	Set frequency
	- Maximum frequency

※The inverter output starts with the start frequency when operation begins, and stops with the stop frequency when operation ends.

※If the upper limit value is less than the lower limit value, the upper limit value overrides the lower limit value.

※When lower limit value is set, the inverter operates with lower limit value at operation command is "ON" even frequency command is zero(0Hz).

F17Gain

‹This function sets the rate of the set frequency value to analog input.

F

1

7

F

R

E

Q

G

A

I

N

Operation follows the figure below.

Set frequency value

200%

+Maximum

100%

frequency

50%

Analog input

-10

0

+10[V]

+10V terminal 12

4

20［mA］ 20mA terminal C1

-Maximum frequency

5-14

Setting range G11S: -400.0 to +400.0Hz P11S: -120.0 to +120.0Hz

The operation follows the figure below.

When the bias frequency is higher than the maximum frequency or lower than the - maximum frequency, it is limited to the maximum or - maximum frequency.

Set frequency value	Bias frequency
	(when positive)

+Maximum frequency

			Analog input
-10	0	+10[V]
			+10V terminal 12
	4	20[mA]	20mA terminal C1

Bias frequency

(when negative) -Maximum

frequency

※Reversible operation is valid if the function code F01/C30 is set to "4" or "5" only.

※This function is invalid if PID control is selected(H20 is "1" or "2").

F20	DC brake	(starting frequency)
F21	DC brake	(Braking level)
F22	DC brake	(Braking time)

‹Starting frequency: This function sets the frequency with which to start a DC injection brake to decelerate the motor to a stop.

F 2 0 D C B R K H z

Setting range: 0 to 60Hz

‹Operation level: This function sets the output current level when a DC injection brake is applied. Set a percentage of inverter rated output current in 1% steps.

	F	2	1	D	C	B	R	K	L	V	L
Setting range					G11S:	0 to 100%
					P11S:	0 to 80%

‹Time: This function sets the time of a DC injection brake operation.

	F	2	2	D	C		B	R	K	t
Setting range 0.0:						Inactive
				0.1 to 30.0 seconds

CAUTION

Do not use the inverter brake function for mechanical holding.

Injury may result.