Fuji Bikes 5000G11S/P11S H07 ACC/DEC （Mode select） pattern, Related functions U02 to U05, Fwd-Cm

H07 ACC/DEC （Mode select） pattern

‹This function selects the acceleration and deceleration pattern.

H 0 7 A C C P T N

Set value 0: Inactive (linear acceleration and deceleration)

1:S-shape acceleration and deceleration (mild)

2:S-shape acceleration and deceleration (*)

3:Curvilinear acceleration and deceleration

Related functions

U02 to U05

* The S-shape range is set by the

function: U02 to U05 when the set value "2" is selected.

The detail is referred to the function: U02 to U05. [S-shape acceleration and deceleration]

This pattern reduces shock by mitigating output frequency changes at the beginning/end of acceleration and deceleration.

Output frequency

	Maximum	Acceleration time	Deceleration time
	output
	frequency
	Set
	frequency
	Base
	frequency
	0
				t[sec]
H08	Rev. phase sequence lock

‹When accidental reversing is expected to cause a malfunction, this function can be set to prevent reversal.

H R E V L O C K

Set value 0: Inactive

1:Active

When reversible operation with polarity(set value: "4" or

Output frequency

f[Hz]

α

α

Mild S-shape ern Arbitrary S-shape

"5") is selected in frequency command: F01, C30, the inverter operates as follows.

Operation			0V to 10V input	-10V to 0V input
command
Short		FWD-CM	The inverter operates.	The frequency display
terminals or				is "0.00" Hz.
	FWD	: ON
Short		REV-CM	The frequency display	The inverter operates.
terminals or			is "0.00" Hz.
	REV	: ON

0 βacc βacc βdec

βdec

t[s]

This function prevents a reversing operation resulting from

<Pattern constants>

	When 1 is selected in H07	When 2 is selected in H07
	(mild S-shape pattern)	(arbitrary S-shape pattern)
Range of	0.05 x max. output freq. (Hz)	(U02 to U05) x max. output
S-shape(α)		freq. (Hz)
Time for
S-shape at	0.10 x acceleration time (s)	(U02, U03) x2 x
acceleration		acceleration time (s)
(β acc)
Time for
S-shape at	0.10 x deceleration time (s)	U04, U05 x2 x
deceleration		deceleration time (s)
(β dec)

∗When acceleration and deceleration times are very long or short, acceleration and deceleration are rendered linear.

It may be switched the acceleration and deceleration time during constant speed or stopping by the function "acceleration and deceleration time selection"(E01 to E09: 4, 5).

The signal may be ignored switched during S-shape at acceleration.

The linear deceleration time is corresponded if switched during S-shape at deceleration.

It may be switched to the S-shape operation if output frequency is reached to the setting frequency or change to acceleration control.

[ Curvilinear acceleration and deceleration ]

This function is used to minimize motor acceleration and deceleration times in the range that includes a constant-output range.

a connection between the REV and P24 terminals, inadvertent activation of the REV key, or negative analog input from terminal 12 or V1. During this function is operating, "0.00Hz" is displayed on the LED monitor.

This function cannot be prevented against H18: Torque control function. It may be reverse because of the torque signal and load.

5-35