Fuji Bikes 5000G11S/P11S To scroll Function Select screen rapidly , use alphabet

The function code consists of alphanumeric characters. Unique alphabetical letters are assigned for each function group.

Table 4-3-1

Function code	Function	Remarks
F00 - F42	Fundamental Functions
E01 - E47	Extension Terminal Functions
C01 - C33	Control Functions of Frequency
P01 - P09	Motor Parameters
H03 - H39	High Performance Functions
A01 - A18	Alternative Motor Parameters
U01 - U61	User Functions
o01 - o55	Optional Functions	Can be selected only with an option connected

To scroll “Function Select” screen rapidly , use alphabet.

∨

>> +

>>

∧ or

+ ∨

>>

+

∨

to move the screen in a unit grouped by

>> + ∧

F00DATA PRTC

F01FREQ CMD 1

F02OPR METHOD

F03MAX Hz-1

F00DATA PRTC

F01FREQ CMD 1

F02PPR METHOD

F03MAX Hz-1

F42TRQVECTOR1

E01X1 FUNC

E02X2 FUNC

E03X3 FUNC

A18SLIP COMP2

F00DATA PRTC

F01DATA PRTC

F02OPR METHOD

Select the desired function and press

FUNC

DATA

to switch to the “data setting” screen.

On the “data setting” screen, the data values on the LCD can be increased or decreased in the smallest

possible unit by pressing	∧	or	∨	Holding down ∧ or ∨ expands the rate of change, thereby
enabling values to be modified more rapidly. Otherwise, select the digit to be modified using >> , then set
data directly. When data is modified, the value before modification will be displayed at the same time for

reference purpose. To save the data, press FUNCDATA . Pressing RESET cancels the changes made and

returns to the “Function Select” screen. The modified data will be effective in inverter operation after the data is saved by FUNCDATA . The inverter operation does not change only if data is modified. When data

setting is disabled in the case of “Data protected” or “Data setting invalid during inverter running,” make necessary changes. Data cannot be modified for the following reasons :

Table 4-3-2

Display	Reason for no modification	Release method
LINK ACTIVE	Currently writing from RS-485/link	Send a cancel command of function
	option to Function is being made.	writing from RS-485.	Stops a
		“Write” operation from the link.
NO SIGNAL(WE)	The edit enabling command function	Among functions E01 to E09, turn the
	is selected using a general-purpose	terminal of data 19 (edit enabling
	input terminal.	command selection) ON.
DATA PRTCTD	Data protection is selected for function	Change function F00 to 0.
	F00.
INV RUNNING	An attempt is made to change a	Stop inverter operation.
	function that cannot be changed
	during inverter operation.
FWD/REV ON	An attempt is made to change a	Turn FWD/REV command off.
	function that cannot be changed
	with the FWD/REV command on.

4-6