User Programming

Programming

3.2 User Programming

The MS-9200UDLS is completely field programmable and requires no special software skills. While programming the MS-9200UDLS, the fire protection capabilities of the

!control panel are enabled.

Site-specific programming may be accomplished in three ways:

•Autoprogramming Feature - This is a convenient method for quickly bringing the FACP addressable SLC devices on-line without the necessity of programming each device individually. Refer to "Autoprogram" on page 47 for a detailed description of Autoprogramming

•Manual programming or editing, using the FACP keypad or a PC keyboard

•Off-line Programming and Editing Feature - allows creation and editing of site- specific custom programs using a Windows-based computer. For programs requiring a large amount of data entry, this method may be preferred. A PK-CD programming kit can be ordered for this purpose

The System All Normal screen will be displayed in a programmed system with no active alarms, troubles or supervisories, as illustrated below:

 

HONEYWELL LIFE SAFETY

 

 

SYSTEM ALL NORMAL

 

 

10:00A

012102

 

 

 

 

Programming, Read Status and Manual Dial mode can be entered while the panel is in

any mode of operation. If the panel is in alarm, the alarm condition must be

acknowledged before entering any other mode. To access any of the programming or

read status features, the Enter or Mode key must be pressed, which will cause the LCD

to display the following:

 

 

 

 

 

1=READ STATUS MODE

 

 

2=PROGRAMMING MODE

 

 

3=MANUAL DIAL MODE

 

 

 

 

Pressing 1, while this screen is being displayed, will cause the control panel to enter the

Read Status Mode which allows the user to view the programmed features and status of

the control panel The Read Status feature is not password protected. Refer to "Read

See Page Status" on page 140 for a detailed description of this feature.

Pressing 2 will select user Programming Mode which may only be accomplished by an authorized person. After pressing 2, a screen will prompt for a password. After entering the correct password, the user may select from a list of programming options.

Pressing 3 will select the Manual Dial Mode which allows the user to enter a troubleshoot mode of operation.

Exit Programming, Read Status and Manual Dial Mode

The programmer can exit any mode by repeatedly pressing the keypad ESC (Escape) key until the display reads System All Normal. Note that the data which is entered during Programming mode is not saved until the programmer exits this mode by repeatedly pressing the ‘ESC’ key. If the Reset key is pressed or power is lost before exiting Programming mode, all data just entered will be lost.

MS-9200UDLS PN 52750:A 11/04/05

43