Master Programming Level

ON BOARD DACT

1=SERVICE TERMINAL 2=CENTRAL STATION 3=MANUAL DIAL MODE

On Board DACT Screen #2

Programming

3.6.9.2.4 Service Terminal

The MS-9200UDLS can be programmed remotely from a PC using a modem and telephone line. Information can also be retrieved from the FACP using the same method. The Upload/Download option allows an operator to set the necessary parameters to allow the uploading and downloading of data between the FACP and PC. The Service Terminal selection provides the means for entering these parameters.

Pressing 1 while viewing On Board DACT Screen #2 will cause the following screens to appear:

SERVICE TERMINAL1=PANEL ID 0000 2=TERMINAL 1 3=TERMINAL 2Service Terminal Screen #1

SERVICE TERMINAL

1=RING COUNT

3

Service Terminal Screen #23.6.9.2.4.1 Panel ID

The Panel Identification Number is a 4-digit code (valid digits being 0 - 9 and A - F) that is used to identify the installed FACP. It is important to program this code into the FACP the first time that downloading is performed so that the called Service Terminal can identify the control panel. The factory default is 0000.

To program the Panel ID, press 1 while viewing Service Terminal Screen #1. The following screen will be displayed:

PANEL ID4 CHARACTER 0-FPanel ID Screen

A flashing cursor will appear in the lower left corner of the display. Enter a 4-digit code using the digits 0 - 9 and/or the letters A - F by entering the first character. Press the right arrow key to move the cursor to the second position and enter the second character. Follow the same procedure to enter the remaining characters. After entering the fourth character, press the right arrow key and then press the Enter key to store the Panel ID number.

MS-9200UDLS PN 52750:A 11/04/05

99