Honeywell UMC800 manual Product Classification Enclosure Rating

Specifications Design

Parameter

System Interconnections

Dimensions

Mounting

Safety Protection

CE Conformity (Europe)

Description

Operator Interface (DISPLAY)

Maximum Distance Between Controller File and Operator Interface: 50 feet

Cable Type: 15 conductor, shielded

Cable termination: 15-pin “D” connector at the controller end; removable screw type terminal strip at operator interface end.

Operator Interface power (24 Vdc) is supplied through the interface cable/connectors.

PC Configurator (CONFIGURATION)

Maximum Distance Between Controller File and PC Configurator: 50 feet

Cable Type: Standard 9-pin RS232, Null Modem

Cable termination: 9-pin “D” connector male (Controller is fitted with female)

Inches: 13.25 wide x 11.87 high x 6 deep

Millimeters: 333.5 wide x 229.2 high x 152.4 deep

Surface mounting with four screws in back of chassis

Optional mounting brackets are available.

Compliant with UL 1092 (draft)/UL 916 Process Control Equipment, CSA, C22.2 No.1010-1 Standard. (24Vdc/ac power certification pending.)

This product is in conformity with the protection requirements of the following European Council Directives: 73/23/EEC, Low Voltage Directive and 89/336/EEC, EMC Directive. Conformity of this product with any other “CE Mark” Directive(s) shall not be assumed.

Product Classification:

Enclosure Rating:

Class I: Fixed, Permanently Connected, Industrial Control Equipment with protective earthing (grounding). (EN 61010-1)

Controller	Open Equipment: IP00. This Multiloop Process Controller must
	be panel mounted within an enclosure (TYPE 1 minimum)
	installed in indoor non-hazardous locations.

Installation Category (Overvoltage Category):

Pollution Degree:

EMC Classification:

Relay / Alarm Outputs:

Operator Interface	Accessory Equipment: The operator interface may be surface
	mounted (IP20, TYPE 2) or panel mounted (IP54, TYPE 12) in
	indoor non-hazardous locations.

Category II: energy-consuming equipment supplied from the fixed installation. Local level appliances, and industrial control equipment. (EN 61010-1)

Pollution degree 2: Normally non-conductive pollution with occasional conductivity caused by condensation. (ref. IEC 664-1)

Group 1, Class A, ISM Equipment (EN 55011, emissions), Industrial Equipment (EN 50082-2, immunity)

Resistive Load: 2 amps @ 240 Vac

98	UMC800 Controller Installation and User Guide	Release F
		4/01