Control panel messages (continued)
Control panel message | Description | Recommended action |
Event Log Empty | SHOW EVENT LOG was selected from | No action necessary. |
| the control panel, and the event log is |
|
| empty. |
|
FLASH DEVICE FAILURE
alternates with
Ready
To clear press 
For the HP Color LaserJet 3700 series printer only.
A device failure has occurred on the specified storage device.
1.Printing may continue for jobs that do not require the Flash DIMM.
2.To remove this message from the display, press 
.
3.If the message persists, remove and
4.If the message persists, replace the Flash DIMM.
Flash disk X initializing
alternates with
DO NOT POWER OFF
FLASH FILE OPERATION FAILED
alternates with
Ready
To clear press 
FLASH FILE SYSTEM IS FULL
alternates with
Ready
To clear press 
FLASH IS
WRITE PROTECTED
alternates with
Ready
To clear press 
Genuine HP supplies installed
The new flash DIMM installed in slot X is initializing.
For the HP Color LaserJet 3700 series printer only.
The printer received a PJL file system command that attempted to perform an illogical operation (for example, to download a file to a
For the HP Color LaserJet 3700 series printer only.
The printer received a PJL file system command that attempted to store something on the file system but was unsuccessful because the file system is full.
For the HP Color LaserJet 3700 series printer only.
The file system is protected and no new files can be written to it.
A new HP cartridge has been installed. The printer returns to the Ready state after approximately 10 seconds.
For the HP Color LaserJet 3700 series printer only.
No action necessary.
1.Printing may continue.
2.To remove this message from the display, press 
.
3.If the message reappears, there might be a problem with the software application.
1.Use HP Web Jetadmin software to delete files from the Flash Memory and try again.
2.To remove this message from the display, press 
.
See HP Web Jetadmin for more information.
1.To enable writing to the Flash Memory, turn off write protection using HP Web Jetadmin.
2.To remove this message from the display, turn the printer off and then back on.
See HP Web Jetadmin for more information.
No action necessary.
GENUINE HP SUPPLIES DESIGNED FOR <PROD>
Incorrect
This genuine HP supply was not | Replace this supply with a genuine HP |
designed for this printer and is not | supply designed for this printer. |
supported. Print quality might be affected. |
|
Access to the menu is restricted. | Contact the network administrator. |
142 Chapter 8 Problemsolving | ENWW |
