Setting the subnet mask
1.Press MENU to enter the MENUS.
2.Press 
to highlight Configure Device.
3.Press 
to select Configure Device.
4.Press 
to highlight I/O.
5.Press 
to select I/O.
6.Press 
to highlight EIO 1.
7.Press 
to select EIO 1.
8.Press 
to highlight TCP/IP.
9.Press 
to select TCP/IP.
10.Press 
to select CONFIG METHOD.
11.Press 
to highlight MANUAL.
12.Press 
to select MANUAL.
13.Press 
to highlight MANUAL SETTINGS.
14.Press 
to select MANUAL SETTINGS.
15.Press 
to highlight SUBNET MASK.
16.Press 
to select SUBNET MASK.
NOTE | The first of four sets of numbers is highlighted. Each set of numbers represents one byte of | ||
| information and has a range from 0 to 255. | ||
| 17. | Press the or arrow to increase or decrease the number for the first byte of the | |
|
| subnet mask. | |
| 18. | Press | to move to the next set of numbers. (Press to move to the previous set of |
|
| numbers.) | |
| 19. | Repeat steps 17 and 18 until the correct subnet mask is entered. | |
| 20. | Press | to save the subnet mask. |
| 21. | Press MENU to return to the Ready state. | |
ENWW | Network configuration 55 |
