HP Saw E4419B manual Off

Menu Reference

Front Panel Menu Reference "Zero/Cal" Menu

■

Cal B

Press this softkey to calibrate channel B with the connected power sensor. The POWER REF output is used as the signal source for calibration and is automatically switched on during this procedure.

■B Ref CF

Press this softkey to enter a reference calibration factor for channel B. A value in the range of 1% to 150% can be entered. The default value is obtained from the sensor calibration table

if one is selected, otherwise it is 100%. Use the , ,

and hardkeys to change the value. To confirm your choice press % . This softkey cannot be selected when you are using an HP E-series power sensor power sensor.

•

Power Ref Off On

	Press this softkey to switch the POWER REF output on or off. This
	output is used as the signal source for calibration. The default is
	“Off”.
Note	During calibration the power meter automatically switches the
	power reference oscillator on (if it is not already on), then after
	calibration it switches it to the state it was in prior to the
	calibration.

•

Must Cal Off On

Press this softkey to switch the Zero/Cal Lockout facility On or Off. When Zero/Cal Lockout is On, the power meter is prevented from making a measurement until the sensor connected has been zeroed and calibrated. This softkey is coupled to the equivalent softkey in the System Inputs menu.

•

TTL Inputs Off On

Press this softkey to disable/enable (Off/On) the ZERO and CAL rear panel TTL inputs.

HP E4419B User’s Guide 3-35