Installation and Configuration

Removing the Autoloader From the Rack

When removing the autoloader from the rack:

■Always use at least two people.

■Install the optional installation brackets if there is no device installed below the autoloader.

■Before powering off the autoloader, remove the magazines.

Standalone Installation

Use these instructions if you will not be installing your autoloader into a rack.

Preparation

To prepare your autoloader for standalone installation:

1.Place one rear standalone leg into place and secure with two screws. Repeat for the other side.

Figure 14: Installing the rear standalone leg

34

SSL1016 Tape Autoloader Reference Guide

Page 34
Image 34
HP SSL1016 manual Standalone Installation, Removing the Autoloader From the Rack, Preparation