This soft copy for use by IBM employees only.
These programs are obtainable in several ways:
•Shipped with the server on two diskettes called the reference diskette and the diagnostic diskette.
•Created from images for these diskettes on the ServerGuide
•On the system partition of the machine.
You can start the system programs in one of two ways:
1.Boot using the system partition.
2.Boot using reference diskette.
The system partition should be used if available. The reference diskette is normally used to:
•
•
Configure and test
Test
•Reconstruct the programs on the system partition of a
•To install the DOS
2.4.1.1 Starting from the System Partition
To start the system programs from the system partition:
1.Turn off the server.
2.Remove all media (diskettes,
3.Turn on the server. The IBM logo appears on the panel.
4.When the F1 prompt appears, press F1. A second IBM logo panel appears, followed by the system programs Main Menu. The Main Menu is shown in Figure 12 on page 19.
To select an option:
1.Use the up arrow key or down arrow key to highlight a choice.
2.Press Enter.
2.4.1.2 Starting from the Reference Diskette
To start the system programs from the reference diskette:
1.Turn off the server.
2.Insert the reference diskette into your diskette drive.
3.Turn on the system.
After a few moments, the system programs Main Menu appears. It will look similar to the one in Figure 12 on page 19.
To select an option:
18PC Server and Windows NT Integration Guide