IBM SG24-4763-00 manual Specifying Additional Adapters

	This soft copy for use by IBM employees only.
￿		￿

Windows NT Server Setup

=======================

Setup has recognized the following mass storage devices in your computer:

Adaptec AHA-294X-394X/AIC-78XX SCSI Controller

*To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows NT, including those for which you have a device support disk from a mass storage device manufacturer, press S.

*If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage device for use with Windows NT, press ENTER.

	S=Specify Additional Device ENTER=Continue	F3=Exit
￿			￿

Figure 56. Disk Controllers Detected During Installation. This panel applies to the PC Servers 325, 330 and 704; other servers are similar.

5.3.3 Specifying Additional Adapters

If the listed disk controllers do not include all the disk controllers in use in your server, continue on here; otherwise skip to 5.3.5, ªSystem Analysisº on page 88.

There are two major reasons why your disk controller may not have been automatically detected:

1.You have more than one controller (for example, an integrated controller and an adapter in a slot) and the controller detected was not the one you have your disks attached to.

2.You have an adapter for which the driver required was not included on the NT 4.0 CD-ROM (for example, the ServeRAID adapter).

In either instance, you will need to press S when the panel shown in Figure 56 is displayed.

84PC Server and Windows NT Integration Guide