This soft copy for use by IBM employees only.
1.Turn on the server and watch the screen.
2.When the message Press <Ctrl><A> appears, press Ctrl and A simultaneously.
A panel similar to the one in Figure 7 will appear.
Adapter
|
|
| ||
|
|
| ||
Would you like to configure the host adapter, or run the | ||||
SCSI disk utilities? Select the option and press <Enter> | ||||
Press <F5> to switch between color and monochrome modes | ||||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
Options | ||||
Configure/View Host Adapter Settings | ||||
SCSI Disk Utilities | ||||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
|
|
| ||
Figure 7. IBM PC Server SCSISelect Utility Program - Main Menu
•Press Enter to go to the Configure/View Host Adapter Settings option.
A panel similar to the one in Figure 8 will appear.
Configuration/View Host Adapter Settings | ||||||
|
|
|
|
| ||
Configuration |
|
|
| |||
|
|
|
|
| ||
SCSI Bus Interface Definitions |
|
|
| |||
Host Adapter SCSI ID |
| 7 |
| |||
SCSI Parity Checking | 1 | Enabled | ||||
Host Adapter SCSI Termination | 2 | Low ON/High OFF | ||||
|
|
|
|
| ||
Additional Options |
|
|
| |||
Boot Device Options |
| Press <Enter> | ||||
SCSI Device Configuration |
| Press <Enter> | ||||
Advanced Configurations Options |
| Press <Enter> | ||||
|
|
|
|
| ||
| <F6> - Reset to Host Adapter Defaults |
| ||||
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
Figure 8. IBM PC Server SCSISelect Utility Program - Host Adapter Settings
The fields on this panel are described as follows:
1 SCSI Parity Checking
Select this option to enable or disable SCSI Parity Checking on the host adapter. If enabled, the host adapter will check parity when reading from the SCSI bus to verify the correct transmission of data from your SCSI devices. SCSI Parity Checking should be disabled if any attached SCSI device does not support SCSI parity. Most currently available SCSI devices do support SCSI parity.
Chapter 2. H a r d w a r e Configuration 13
