
This soft copy for use by IBM employees only.
|
|
|
|
| ||
| View Configuration |
| ||||
|
|
|
| |||
|
|
|
|
|
| |
|
| Total System Memory |
|
|
| |
|
| Installed memory....................................32768KB(32.0MB) |
| |||
|
| Usable Memory.......................................32584KB(31.6MB) |
| |||
|
| Built In Features |
|
|
| |
|
| Installed Memory....................................32768KB(32.0MB) |
| |||
|
| Diskette drive 0 Type...............................2.88MB 3.5″ |
| |||
|
| Math Coprocessor....................................Installed |
| |||
|
| Num Lock | Off |
| ||
|
| Display F1 prompt...................................Yes |
| |||
|
|
| ||||
|
| First Serial Port(A)................................SERIAL 1, IRQ4 |
| |||
|
| Second Serial Port(B)...............................SERIAL 2, IRQ3 |
| |||
|
| High Speed Parallel Port A..........................Parallel 1 |
| |||
|
| Parallel Port A DMA Arbitration Level...............Shared level 7 |
| |||
|
| Parallel Port A SCB I/O address | 8100 - 8102 |
|
| |
|
| Unauthorized - Access Monitor.......................Enabled |
| |||
|
| Usable |
| |||
|
| Bypass system programs on error.....................Disabled |
| |||
|
| Processor | 90MHz Pentium |
| ||
|
|
|
|
| ||
|
| Interrupt Level.....................................Level E |
| |||
|
| BIOS Base |
| |||
|
| I/O address |
| |||
|
| DMA arbitration level...............................Level 8 |
| |||
|
| Tower configuration.................................2 Towers |
| |||
|
| Data parity exception handling support..............Enabled |
| |||
|
| Micro Channel streaming.............................Enabled |
| |||
|
| INT 13 Support......................................Enabled A |
| |||
|
| Slot2 - Empty |
|
|
|
|
|
| Slot3 - Empty |
|
|
|
|
|
| Slot4 - Empty |
|
|
|
|
|
| Slot5 - SVGA Adapter |
|
|
| |
|
| ROM address |
| |||
|
| F1=Help | F3=Exit | F8=Fwd |
| |
|
|
|
|
| ||
|
|
|
|
Figure 15. System Programs - View Configuration Panel
Booting from a RAID Drive
If you plan to install your operating system on a drive that is connected to a RAID controller, ensure you have INT 13 Support (shown at A in Figure 15) set to Enabled.
If you do not, you will not be able to boot any RAID
Chapter 2. H a r d w a r e Configuration 23