CHAPTER 11

MINIMUM HARDWARE SETUP

This chapter discusses the basic operating requirements of the MCS® 251 microcontroller and de- scribes a minimum hardware setup. Topics covered include power, ground, clock source, and de- vice reset. For parameter values, refer to the device data sheet.

11.1 MINIMUM HARDWARE SETUP

Figure 11-1 shows a minimum hardware setup that employs the on-chip oscillator for the system clock and provides power-on reset. Control signals and Ports 0, 1, 2, and 3 are not shown. See sections 11.3, “Clock Sources” and 11.4.4, “Power-on Reset.”

C1

C2

8XC251Sx

VCC

VCC2

XTAL1RST

XTAL2

VSS

VSS1

VSS2

VCC

+

1µF

Note:

VCC2 is a secondary power pin that reduces power supply noise. VSS1 and VSS2 are secondary ground pins that reduce ground bounce and improve power supply by-passing. Connections to these pins are not required for proper device operation.

A4141-02

Figure 11-1. Minimum Setup

11-1

Page 188 Page 190
Page 189
Image 189
Intel Embedded Microcontroller, 8XC251SA, 8XC251SP, 8XC251SQ, 8XC251SB manual Minimum Hardware Setup, Minimum Setup
Page 188 Page 190

Embedded Microcontroller, 8XC251SP, 8XC251SA, 8XC251SQ, 8XC251SB specifications

The Intel 8XC251 series of embedded microcontrollers is a family of versatile and powerful devices, designed to meet the demands of a wide range of applications. With models such as the 8XC251SB, 8XC251SQ, 8XC251SA, and 8XC251SP, this series offers unique features while maintaining a high level of performance and reliability.

At the heart of the 8XC251 microcontrollers is the 8051 architecture, which provides a 16-bit processor capable of executing complex instructions efficiently. This architecture not only allows for a rich instruction set but also facilitates programming in assembly language and higher-level languages like C, which are essential for developing sophisticated embedded systems.

One of the significant features of the 8XC251 family is its integrated peripherals, including timer/counters, serial communication interfaces, and interrupt systems. These peripherals enable developers to implement timing functions, data communication, and real-time processing, all of which are crucial in modern embedded applications. The 8XC251SB and 8XC251SQ models, for instance, come equipped with multiple I/O ports that allow for interfacing with other devices and systems, enhancing their functionality in various environments.

The memory architecture of the 8XC251 devices is noteworthy, featuring on-chip ROM, RAM, and EEPROM. The on-chip memory allows for fast access times, which is essential for executing programs efficiently. Moreover, the EEPROM serves as non-volatile memory, enabling the storage of configuration settings and important data that must be retained even when power is lost.

In terms of operating voltage, the 8XC251 devices are designed to operate in a wide range, typically between 4.0V and 6.0V. This flexibility makes them suitable for battery-powered applications, where energy efficiency is critical. The power management features, including reduced power modes, further enhance their suitability for portable devices.

Lastly, the 8XC251 series is supported by a wide range of development tools and resources, allowing engineers and developers to streamline the development process. This support, combined with the microcontrollers' robust features, makes the Intel 8XC251 family a reliable choice for various embedded applications, such as industrial automation, automotive systems, and consumer electronics.

Overall, the Intel 8XC251SB, 8XC251SQ, 8XC251SA, and 8XC251SP deliver high performance, versatility, and ease of use, making them a preferred choice for embedded system designers looking to develop efficient and effective solutions.
Top Page Image Contents