Oki 6100E+ manual Configuring HP-UX v9.xx for Printing with the OkiLAN 6100e+, Usr/lib/lpsched

Section 4 - Appendix B - Application Considerations

6. Enable the printer you just created using SAM. Peripheral Devices ->

Printers and Plotters -> Enable a Printer ...

7.Printer name: — lj4

8.Start the LP request scheduler by typing:

/usr/lib/lpsched

9.Run a test print job to the OkiLAN 6100e+ with the following command:

lp -d lj4 filename

Configuring HP-UX v9.xx for Printing with the OkiLAN 6100e+

This application note describes the configuration of the printing system on the HP-UX ver. 9.xx of the UNIX operating system. For clarity and brevity, the following specific names will be used to represent general devices or concepts.

•lj4 - The local queue name on the HP-UX system to which print jobs will be directed. The print jobs are destined for a printer attached to the OkiLAN 6100e+.

•OKIPRINTER - The host name of the remote system which is the OkiLAN 6100e+. For example, to telnet to the OkiLAN 6100e+ and invoke the OkiLAN 6100e+ Configuration utility, you would type telnet OKIPRINTER. A host name is not required for the OkiLAN 6100e+, the IP Address may be used.

•yourqueuename - This is the name of the queue on the OkiLAN 6100e+ and must end with 1, 2, 3 or 4, depending on the port selected to service the print jobs.

If FF, LF or NF are the last two letters of the queue name, the job will be converted accordingly. See pages IV-15 and IV-16 for more information on Remote Queue Names.

TCP/IP

OKI OkiLAN 6100e+ User’s Guide IV - 65