User’s Manual of
6. Command Line Mode
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command modes are described below. Each of the command modes supports specific software commands.
Command Groups:
System | System settings and reset options |
|
|
IP | IP configuration and Ping |
|
|
Port | Port management |
|
|
Aggr | Link Aggregation |
|
|
LACP | Link Aggregation Control Protocol |
|
|
RSTP | Rapid Spanning Tree Protocol |
|
|
Dot1x | IEEE 802.1X port authentication |
|
|
IGMP | Internet Group Management Protocol snooping |
|
|
LLDP | Link Layer Discovery Protocol |
|
|
MAC | MAC address table |
|
|
VLAN | Virtual LAN |
|
|
PVLAN | Private VLAN |
|
|
QoS | Quality of Service |
|
|
ACL | Access Control List |
|
|
Mirror | Port mirroring |
|
|
SNMP | Simple Network Management Protocol |
|
|
Stack | Stack management |
|
|
Firmware | Download of firmware via TFTP |
|
|
6.1 System Command
System Configuration
Description:
Show system configuration.
Syntax:
System Configuration [all] [<port_list>]
Parameters:
212