![](/images/new-backgrounds/1117458/11745857x1.webp)
User’s Manual of
Approved PLANET SFP Transceivers
PLANET Managed Switch supports both Single mode and
■
■
■
■
■
■
It recommends using PLANET SFPs on the Managed Switch. If you insert a SFP transceiver that is not supported, the Managed Switch will not recognize it.
Before connect the other Managed Switches, workstation or Media Converter.
1.Make sure both side of the SFP transceiver are with the same media type, for example:
2.Check the
¾To connect to
¾To connect to
Connect the fiber cable
1.Attach the duplex LC connector on the network cable into the SFP transceiver.
2.Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media Converter..
3.Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is operating correctly.
4.Check the Link mode of the SFP port if the link failed. Co works with some
Remove the transceiver module
1.Make sure there is no network activity by consult or check with the network administrator. Or through the management interface of the switch/converter (if available) to disable the port in advance.
2.Remove the Fiber Optic Cable gently.
3.Turn the handle of the MGB module to horizontal.
4.Pull out the module gently through the handle.
29