Q-Logic 8200 SERIES manual Task Roadmap, Roadmap of Setup Tasks

Section 3

Getting Started with SANbox SSP

This section describes the tasks you must perform before you begin to install, configure, and operate the SANbox SSP. The tasks should be performed in the order presented in this section.

This section covers the following tasks:

■Task Roadmap

■Checking Package Contents

■Setting Up SANbox SSP

■Managing your Configuration

3.1

Task Roadmap

Table 3-1presents the roadmap for setup tasks.

Table 3-1. Roadmap of Setup Tasks

	For This Setup Step:	See:
1.	For a high-availability system,	■ "High-Availability Configuration" on page 2-6for
	obtain information about	overview information.
	high-availability configurations	■ "Setting up a High-Availability Configuration" on
	that use SANbox SSPs and SVM	page 5-1for specific information about setting up
	appliances.	each component of a high-availability system.
2.	Unpack and set up the hardware:	■ "Checking Package Contents" on page 3-2.
	mount the SANbox SSP in a rack,	■ "Setting Up SANbox SSP Hardware" on
	install the power supplies, and	page 3-4.
	connect the console port.
3.	Start up and configure the SANbox	■ "Accessing SANbox SSP for the First Time" on
	SSPs: configure the terminal	page 3-7.
	settings on the host, use the serial	■ "Accessing SANbox SSP for the First Time" on
	console port, and modify the	page 3-7.
	Ethernet settings for remote
	access.
4.	Connect SVM appliances,	■ "Connecting to the SAN" on page 3-9.
	SANbox SSPs, and hosts to the
	SAN.

SN0054628-00 A 3-1