Q-Logic 8200 SERIES manual Quit Command, Reboot Command, Reset Port Command, Reset port

Q

B – Command Reference Commands

See Also "Disable User Command" on page B-10 "Enable User Command" on page B-11 "Modify User Command" on page B-16 "Show User Command" on page B-27 "Show Users Command" on page B-27

Quit Command

Exits this command line interface session, terminates the telnet session, and logs the user out.

Syntax quit

See Also "Exit Command" on page B-12

Reboot Command

Restarts the SANbox SSP.

Syntax reboot

Reset Port Command

	Shuts down the port and then restarts it, leaving the properties of the port
	unchanged. Use this command to clear a port that is in an unknown state and
	trigger the discovery process.
	WARNING!! Running this command disrupts any traffic on this port, and should
	never be performed on a port that is moving data. Doing so could
	cause read/write failure and error conditions in software if traffic has
	occurred.
Syntax	reset port
	[port number]
	*
Keywords	reset port [port number]
	An integer 1-8 for SANbox 8200-08 SSP/SANbox 8202-08 SSP or 1-16 for
	SANbox 8202-16 SSP to indicate the Fibre Channel port.
	reset port *
	* indicates all Fibre Channel ports.
See Also	"Modify Ports Command" on page B-15
	"Show Port Command" on page B-23
	"Show Ports Command" on page B-24

SN0054628-00 A B-17