Ricoh 170 / 180 manual Communication Problems, Operating Difficulties, Symptom Required Action

COMMUNICATION PROBLEMS

6.Close the printer paper cover until it audi- bly locks into place.

7.Tear off the excess paper: Press the Start key.

COMMUNICATION PROBLEMS

If the Check Display indicator is lit and the message "ERRORPRESSSTOP" appears on the display, a communication has just failed. Press the Stop key to return the machine to standby mode. If it was:

❐An error during transmission: Resend the fax message. If the same problem happens again, call the other party to make sure that their fax machine is working.

❐An error during reception: Call the sender and ask them to send the message again.

OPERATING DIFFICULTIES

Symptom	Required Action
The display is blank.	If the power indicator is not lit, check that the
	power cord is plugged in properly.
The machine cannot dial out	The number must contain the access code. A
from behind a PBX.	pause may also be necessary after the access
	code; if there is one already, try adding more
	pauses.
The telephone keeps ringing	You are in Manual (TEL ) receive mode. Switch
and no fax is printed.	to Auto or Fax mode.
	The power cord is unplugged.
You cannot receive phone	You are in Fax mode. Switch to Auto or Tel
calls; the unit only rings then	mode.
goes into fax receiving mode.
You cannot receive incoming	Your machine’s telephone line cord is
calls; the unit does not ring.	disconnected.
Dialing is possible, but	ID Codes do not match. Contact the other party
Secured Polling is not.	and agree on an ID Code.
The Check Display indicator	There is a problem, check the error display and
is lit	correct the faults.
You hear an unusual noize	The green levers are not pulled down correctly.
when closing operation	Pull down the levers to the bottom.
panel.

96