Additional Information and Errata

[P51] Receiving with Auto Select mode

1.The machine start ringing.

2.You have two options:

Pick up the handset. If a person is at the other end, you can continue a nor- mal conversation. However, if it its a fax machine (if you hear the tone), press the Start key, then replace the handset to receive the message.

Do nothing. The machine keep ringing. After a number of rings (the auto ring time ) the machine will begin to receive a message. You can change the number of rings (the auto ring time) - see page 49.

[P15, 103, 103 and 105] Opening the printer cover

The printer cover catch is located in the center of the cover. To release the printer cover, you need to squeeze the catch Backwords -see opposite. the cover will spring out slightly allowing you to raise it up.

NOTE: The catch must be squeezed backwards. If you apply too much pressure in the opposite direction the catch will become detached from the machine. If this happens, follow the instruc- tions below.

Reattaching the printer Cover Catch

If your printer cover catch becomes detached, it can be easily be fixed. While holding printer cover open, push the catch back into position in the direction shown opposite. The catch should click into place.

[P106] eplacing the carriage

WhenPAPERyou close the printer cover, but the " REPLACE " or "CLEARCOPY" is still displayed, please check the position of the carriage. It should be left side.

If it is not in that position, slide it back to the left.

Part No. H0688698

Page 147
Image 147
Ricoh 170 / 180 manual P15, 103, 103 and 105 Opening the printer cover, P106 eplacing the carriage