Additional Information and Errata

[P51] Receiving with Auto Select mode

1.The machine starts ringing.

2.You have two options:

Pick up the handset.

If you hear a voice then continue a normal conversation.

If you hear a tone then the other end is a fax machine. Make sure the document feeder is empty, press the Start key to start receiving and replace the handset. If you do not replace the handset or press the Start key, after a few seconds the machine will automatically take the line and receive the message.

Do nothing. The machine will keep ringing. After a number of rings (the auto ring time ) the machine will begin to receive a message. You can change the number of rings (the auto ring time) - see page 49.

[P14, 92, 93 and 95] Opening the printer cover

The printer cover catch is located in the center of the cover. To release the printer cover, you need to squeeze the catch backwards - see opposite. The cover will spring out a little. Then grasp the paper guides and raise the cower up.

NOTE: The catch must be squeezed backwards. If you apply too much pressure in the opposite direction the catch will become detached from the machine. If this happens, follow the instruc- tions below.

Reattaching the printer cover catch

If your printer cover catch becomes detached, it can easily be fixed. While holding the printer cover open, push the catch back into position in the direction shown opposite. The catch should click into place.

[P95] Replacing the carriage

IfPAPERyou close the printer cover and " REPLACE

" or "CLEARCOPY" is still displayed, please check the position of the carriage. It should be on the left side. If it is not in that position, slide it back to the left.

NOTE: If the carriage sticks halfway, the transparent plastic strip may be blocking it - pull it out slightly from the rear of the machine to let it pass.

Part No. H0688697

Page 146
Image 146
Ricoh 170 / 180 manual P51 Receiving with Auto Select mode, P14, 92, 93 and 95 Opening the printer cover