Ricoh 170 / 180 Switching Reports ON/OFF, Power Failure Report Type I Only, Switch Digit Purpose

SWITCHING REPORTS ON/OFF

Power Failure Report (Type I Only)

This report is printed if the machine’s power was off long enough to erase the memory. The report gives details of the files that were lost. With this information, you may store messages for transmission again, and contact the senders of any received messages that were lost.

Polling Clear Report (Type I Model)

This is printed after a polling file has been erased from memory.

SWITCHING REPORTS ON/OFF

Some of these reports can be switched on or off. To switch a report on or off, do the following (see page 102 if you need more information about User Parameter

settings adjustment procedure).
1.	Press the Function key and	SWITCH03:0000KPAD/Y/0000jk
		SETTING?	Y/j
	6,2,2,2,2,6,3 using the ten keypad, then	PRINTLISTj
	press the Yes key.		KPAD/Y/jk
2.	Press the Yes key. The settings for
	Switch 00 are now displayed.	SWITCH00:00000000

3.Press the jand kkeys until the settings for Switch 03 are displayed.Each digit from 0 to 7(except digit 1) controls a re- port.

Switch 03

Digit	Purpose
0	Communication Result Report (Memory Transmission)
	(Type I Only)	0: Off	1: On
1	Do not change this setting.
2	File Reserve Report (Memory Transmission)
	(Type I Only)	0: Off	1: On
3	File Reserve Report (Polling Reception)	0: Off	1: On
4	Communication Result Report (Polling Recption)
		0: Off	1: On
5	Transmission Result Report
	(Immediate Transmission)	0: Off	1: On
6	Polling Clear Report (Type I Only)	0: Off	1: On
7	TCR	0: Off	1: On

86