SAGEM 3P@C

6.3.4.Command Line Edit Feature

Table 6-4 lists the line editing commands that can be used in the command line.

Table 6-4 Line edit commands in the command line

Command

Function

Back Space or Del or

Deletes a character to the left

Ctrl+h

 

Up arrow key, or Ctrl+p

Invokes the previous history command

Left arrow key or Ctrl+b

Moves the cursor to the left by a character

Right arrow key or Ctrl+f

Moves the cursor to the right by a character

Down arrow key or Ctrl+n

Shows the next history command if the up arrow

 

key has been used previously to invoke the

 

previous history command

Ctrl+a

Moves the cursor to the beginning of the line

Ctrl+e

Moves the cursor to the end of the line

Ctrl+d

Deletes the character where the cursor is

Ctrl+k

Deletes all characters after the cursor

Ctrl+t

Changes the character where the cursor is with

 

that on the left of the cursor, and moves the

 

cursor to the right by a character

Ctrl+u

Deletes the whole line

Ctrl+w

Deletes all characters on the left of the cursor

Of the above commands, Del, up arrow key, down arrow key, left arrow key and right arrow key only support the mode of using Telnet to configure the switch, rather than

serial interface configuration. However, the Ctrl+h, Ctrl+p,

prompt Ctrl+b, Ctrl+f and Ctrl+n commands all support the above two login modes.

For details of the commands, see the 3P@C 4450E IP-

DSLAM Software Configuration Manual.

prompt

6.4.System Management

6.4.1.Storage Media and File Type

The 3P@COS, configuration file and other applications of 3P@C 4450E are saved in the Flash. See Table 6-5 for the related file types.

Table 6-5 Correspondence between file types and command line parameters of 3P@C 4450E

Parameter

Description

3P@COS

3P@COS operating system

config-file

Configuration file

adufpgavdubfpga

FPGA code of ADU and VDU

3P@C Installation Manual

Page 6-6 Reproduction and communication in any form prohibited without the written permission of SAGEM SA