SAGEM 3P@C

Uncompress success, enter device initialize, Please wait...

Entering 3P@COS ......Done.

Initializing environment ...... Done.

Loading startup config ...... Done.

########################################################

###

 

#

#

 

#

#

Welcome to 3P@COS.

#

#

 

#

#

Press Return to connect and config this system.

#

#

 

#

########################################################

####

3P@COS V2.0Release7.4.0 on 3P@C 4450EV2.0.

Login:

Step 3 When pressing <Enter> on the terminal, the system prompts you to input the login user name and password.

Step 4 The default user name for the login at the first time is “admin” and the password is “3P@C”. The user logging in with this user name and password has the administrator rights. The display is shown as follows:

Login: admin

Password: *******

You will first enter the read-only mode of the system after successfully logging into the system. The command prompt is “3P@C>“. In this mode, you can only view the system configuration information, since common users can only enter the read-only mode. If you have the administrator rights and hope to configure the equipment, enter the configuration mode according to Step 4.

Step 5 Enter the configuration mode.

Input the enable command in the read-only mode. Then the system requests you to input the password for entering the configuration mode. The default password is “3P@C”, as shown in the following:

3P@C>enable Password: *******

After you successfully enter the configuration mode, the command prompt becomes “3P@C(config)#”. In this mode, you can perform all the configuration operations on 3P@C 4450E. For the detailed description of the related configuration commands and methods, please refer to the 3P@C 4450E IP-DSLAM Configuration Manual.

Step 6 Save the configuration information.

To make the equipment configuration still effective after the equipment is restarted, you need to use the save configuration command to save the configuration information. For example,

3P@C(config)# save configuration

Press Enter and wait for the system to save the configuration information.

Step 7 Exit the configuration mode.

In the Configuration Mode, you may use the exit command to exit the Configuration Mode and go back to the read-only mode. You may also use the exit command in the read-only mode. However, it only functions to exit the 3P@COS, similar to the function of the logout and quit commands.

To exit the 3P@COS, use the logout or quit command, or use the exit command in the read-only mode.

3P@C Installation Manual

Page 6-2 Reproduction and communication in any form prohibited without the written permission of SAGEM SA