SAGEM 3P@C

Figure 12-7 Connection of splitters

Note

Fax machine

External line

Splitter

Telephone

Extension

Computer

Some Modems are in-built with splitters, and the connection of the ports can be done as shown in the figure above.

2) Connection, configuration and commissioning of Modems

Confirm the normality of lines and the proper installation of central office terminals, and the Line cables and POTS cables having been connected to the distribution frame. Try to make a call for its normal use, if it cannot be made or gets line crossed, the wires may be correctly bonded, and should be done again; if the call can be normally made, the next is to connect, configure and commission the Modem. Take the Modem of the in-built splitter for example, the method is described as follows:

„Connect the Modem with the telephone wire, and connect the network cable to the network adapter of PC.

„Complete the related network configuration and subscriber authentication setting.

„Power on the Modem and wait for over ten seconds, and the SYNC indicator of the Modem is on, showing that the VDSL link has been established.

„Try to access the Internet, if it is possible, it shows the commissioning of VDSL.

Recording the User Information and Relevant Data

For the convenience of the later operation maintenance, the user information and the data for the initially commissioned line connection. For details, see Table 12-9 and 12-13:

3P@C Installation Manual

Page 12-21 Reproduction and communication in any form prohibited without the written permission of

SAGEM SA