SAGEM 3P@C
6.3.Command Line System
3P@C 4450E adopts the 3P@COS. 3P@COS is the operating system developed specially for its 3P@C series of products.
Note
All the commands of the 3P@COS command line are case insensitive.
6.3.1.Command Mode
There are two command modes for the 3P@C 4450E
Table
Command | Function |
| Applicable | Command |
mode |
|
| users | prompt |
View most of the system | Ordinary | 3P@C> | ||
mode | information | and | user |
|
| configuration information of |
|
| |
| the switch |
|
|
|
Configuration | View and configure all the | Administrator | 3P@C(config)# | |
mode | information of the switch |
|
|
The user that logs in the system with default user name “admin” and password “3P@C” is called an administrator who can configure and operate the switch in both
6.3.2.Common Commands
For a preliminary understanding of the usage of the 3P@C 4450E commands, the following introduces the usage method of some common commands, as shown in Table
Table
Command | Function |
clear | Clears the screen display |
enable | Enters the configuration mode to perform |
| configuration and write operations on the switch |
exit | Exits the current configuration mode and returns |
| to the previous mode. If executed in the |
| mode, this command will enable users to exit |
| from the system. |
help | Shows how to use the syntax help in the |
| command line |
list | Shows the list of current available commands |
logout | Logs out and disconnects |
3P@C Installation Manual
Page