Sagem 4450E manual 5

TABLE OF CONTENTS

Use Guide to This Manual				13
Part	I 16
1. Overview of the 3P@C 4450E IP-DSLAM				1-1
1.1.		SYSTEM OVERVIEW		1-1
1.2.		REPRESENTATIVE NETWORKING APPLICATIONS		1-1
1.3.		SYSTEM COMPOSITION		1-2
1.4.		HARDWARE FEATURES		1-3
2. 3P@C 4450E Hardware Structure				2-1
2.1.		SHELF CONFIGURATION		2-1
	2.1.1. Structure of the General Chassis			2-1
	2.1.2.		10U Chassis	2-3
	2.1.3.		Fan Module	2-4
	2.1.4.		Air Deflector Frame	2-4
2.2. FULL CONFIGURATION OF THE CABINET				2-6
2.3.		SMUB AND SERVICE BOARDS		2-7
	2.3.1. Service Processor Unit Board (SMUB)			2-7
	2.3.2. VDSL Unit Board (VDUB)			2-10
	2.3.3. ADSL Unit Board (ADUB)			2-11
	2.3.4. ADSL Unit Card (ADUC)			2-13
2.4.		POWER DISTRIBUTION SYSTEM		2-14
	2.4.1.		Overview	2-14
	2.4.2.		Functional Features	2-14
2.5. OPTIONAL UPLINK INTERFACE MODULES				2-15
	2.5.1. 1-port Gigabit Long-wave Optical Interface Module (DS-1GLX)			2-15
	2.5.2. 1-port Gigabit Short-wave Optical Interface Module (DS-1GSX)			2-17
	2.5.3. 2-port 100M Multi-mode Optical Interface Module (DS-2FMM)			2-18
	2.5.4. 2-port 100M Single-mode Optical Interface Module (DS-2FSM)			2-19
	2.5.5. 4-port 100M Electrical Interface Module (DS-4TXB)			2-21
	2.5.6.		VAS Card (DS-4ITX)	2-22
2.6. ROUTE TRANSFER UNIT (RTU)				2-23
3.	Installation Preparation			3-1
3.1.		ENVIRONMENTAL REQUIREMENTS		3-1
	3.1.1. Temperature and Humidity Requirements			3-1
	3.1.2.		Cleanness Requirements	3-1
	3.1.3.		Floor Requirements	3-1

3P@C Installation Manual

Page 0-4Reproduction and communication in any form prohibited without the written permission of SAGEM SA