SAGEM 3P@C

To unpack the packing box of the cabinet, take the following steps:

Step 1 Open the upper cover. Place the packing box as indicated and use a claw hammer or screwdriver to remove the plastic clips around the top cover. The cabinet is exposed.

prompt

Since the cabinet is rather heavy, three to four persons are needed to cooperate with one another in the unpacking process.

Step 2 Erect the packing box and pull out the two cabinet feet. Erect the packing box to its normal position. Hold the packing box and carefully drag outward the cabinet from the side where the cover is removed, until the two cabinet feet are dragged out of the packing box. Remove the foam pads under the cabinet feet and place the cabinet feet on the floor.

Step 3 Slightly lean the packing box along with the cabinet towards the side where the cover is removed, and use the supports of the two cabinet feet on the floor to draw back the packing box from the reverse direction, as shown in Figure 3-5.

prompt

Since the equipment is rather heavy, please operate it carefully. Raise and hold rigid places such as the rack base and skeleton to avoid damaging the equipment or any other accidents.

Figure 3-5 Draw out the packing box backward from the reverse direction

3P@C Installation Manual

Page 3-13 Reproduction and communication in any form prohibited without the written permission of SAGEM SA