SAGEM 3P@C
Format of configuration file
Saved in the command form
Only
The configuration file is based on the command mode. The commands with the same command mode are listed together. Different command modes are separated by blank lines or remark lines (the lines starting with a “!”).
End with “end of config”
To view the content of the configuration file, execute the following commands in the configuration mode: Configuration procedure:
Step 1 | show | View the initial configuration of the |
|
| equipment |
Step 2 | show | View the current configuration of the |
|
| equipment |
The following is a configuration file:
Configuration example:
3P@C (config)# show
!3P@COS system config file
!preconfig config
!Syslog config
config syslog
Note that the command starting with “!” is remark information.
7.2.2.Backuping the Configuration File
After the user configures the equipment, the user is suggested to backup the configuration file. Then, the user can download the configuration file to the equipment, or load the configuration file to the equipment with similar configuration in case of need.
The example below instructs you how to transfer the system file. The IP address of the FTP server is 20.1.1.1, and the configuration file is renamed as config.txt after the configuration file is transferred to the FTP server.
3P@C 4450E operation procedures:
Step 1 First enable the FTP server and set the user name and password. For example, the user name is “ftpuser” and the password is “123”.
Step 2 Transfer the system configuration file, and execute the commands below in the 3P@C 4450E equipment:
3P@C Installation Manual
Page | Reproduction and communication in any form prohibited without the written permission of |
SAGEM SA