SAGEM 3P@C
a |
| - Download system image to Flash |
A |
| - Download system image and boot |
s |
| - Download system base config information |
fa |
| - Download ADU fpga code |
fv |
| - Download VDU fpga code |
da |
| - Download ADU chip code |
dv |
| - Download VDU chip code |
load | <filename> | - Download file to Flash |
del | <filename> | - Delete a file in Flash |
rename <oldname> <newname> - Rename a file in Flash | ||
erase fileinfo | - Erase files in Flash, all files will be lost! | |
show flash | - Show Flash file info | |
x |
| - Quit |
For the description of menu options, see Figure
Enter a command n, you can select either Xmodem or FTP mode. Here, select Xmodem.
Step 5: Enable the corresponding function option to download the software
Enter a command a, and the system prompts:
Downloading, please wait...
Please set console baud rate 115200
When you user the 3P@C 4450EV2.00 hardware, the system will prompt you to modify the baud rate as 115,200. In the case
of the 3P@C 4450EV2.00 hardware, the baud rate needs to be
prompt set to 9,600 when you connect 3P@C 4450E through the serial port. Then, you need to disconnect 3P@C 4450E first, modify the baud rate, and connect 3P@C 4450E again.
The system is waiting for the terminal to send files through the Xmodem protocol. Click [Send/Send files] to initiate the function of sending files, and select the [Xmodem] protocol. Click <Browse> to choose the path of the main file, and click <Confirm>. The terminal begins to send files, as shown in the figure below:
3P@C Installation Manual
Page