SAGEM 3P@C

In the following procedures, 3P@C 4450E serves as the FTP client, and the remote PC (containing the system file) serves as the FTP server.

Suppose that the IP address of the PC server is 10.1.1.2/24 and that the FTP Server service is enabled. Implement the following procedures in 3P@C 4450E.

Step 1: Connect the equipment to the PC through a network

Figure 7-4 Connection mode

Connect the console port

PC server:

of the equipment

 

Terminal

 

Step 2: Configure the IP address of the equipment interface, and ensure that you can PING through the server

Step 1

Step 1: The user with the administrator right logs in and enters the

 

configuration mode through the serial port or telnet.

 

3P@C> en

 

Password:

 

3P@C(config)#

Step 2

Configure 3P@C 4450E and the host where the downloaded file is located

 

well so that they can communicate with each other normally. Enable the

 

FTP Server in the host, and configure the login user name, password and

 

path of downloading the file.

 

3P@C(config)#

Step 3

Check whether the interworking with the FTP Server.

 

3P@C(config)#Ping 10.1.1.2

Step 3: Log in to 3P@C 4450E, and download the required file

Step 1 Log in to 3P@C 4450E, input the user name and password to download the required file.

3P@C(config)# download ftp [3P@COSconfig-filexducodevduos] <A.B.C.D> <username> <password> <filename>

Step 4: Reboot 3P@C 4450E

Step 1 After the download, input the reboot command to reboot the switch.

3P@C(config)# reboot

The following information indicates the download through FTP is successful: Trying download file from ftp server, please wait...

Successfully finished receiving file.

Trying write file to flash......

Finished.

You've successfully download new image file

Now you can type reboot command to reboot system.

3P@C Installation Manual

Page 7-9 Reproduction and communication in any form prohibited without the written permission of SAGEM SA