SAGEM 3P@C

Figure 3-3 Packing structure of the equipment inside the packing box

Air deflector frame

Fan module

Paper board

Foam pad

10U chassis

Packing box

 

The above figure indicates the structure of the packing box

 

inside and shows the packing materials such as antistatic

prompt

plastic bag and desiccant.

To unpack the packing box, take the following steps:

Step 1 Remove the outside packing materials.

Place the packing box as indicated and use a claw hammer or screwdriver to remove the plastic clips around the top cover. The upper cover can be opened.

Step 2 Remove the equipment packing materials.

Remove the packing materials (e.g. foam pads) on the equipment and carefully and smoothly draw out the equipment. Remove the packing plastic bag of the equipment.

 

 

If the equipment is moved from a place with low temperature

 

 

and low humidity to another place with high temperature and

 

 

high humidity, you have to wait at least 30 minutes before

 

 

unpacking it so as to avoid damages to the equipment

 

Note

 

caused by the moisture condensed on the equipment

 

 

surface.

 

 

 

 

 

Since the equipment is rather heavy, please operate it

 

 

carefully and avoid colliding with human or articles. Raise

 

 

and hold rigid places such as the rack base and skeleton to

 

Note

 

avoid damaging the equipment or any other accidents.

3P@C Installation Manual

Page 3-11 Reproduction and communication in any form prohibited without the written permission of SAGEM SA