Sun Microsystems 6.0005E+11 manual 22Removing or Installing a Graphics UPA Card

3

Figure 3-22Removing or Installing a Graphics (UPA) Card

7.Place the card in an antistatic bag.

8.If the graphics (UPA) card is not immediately replaced, install a filler panel (part number 340-2305) on the Graphics I/O board back panel opening. To secure the filler panel, use the screws that were removed in Step 3.

Caution – Be sure to install the filler panel right-side up. Installing it upside

!down creates a gap at the top edge of the card slot opening that can impair system cooling and regulatory compliance.

9.Use the procedures in Section 3.5.3, “Installing a Board,” to replace the Graphics I/O board.

I/O Boards and Components 3-29