
E
3.Tilt the top bezel at a 45o angle and insert the lip of the bezel under the top of the enclosure.
See Figure
4.Lower the top bezel.
The top bezel should snap into place.
5.Replace the system key.
6.Power on the Enterprise system.
See the power on instructions in Chapter 12, “Powering Off and On.”
E.2.3 Centerplane
To remove the centerplane:
1.Completely power off the Enterprise system.
See the power off instructions in Chapter 12, “Powering Off and On.”
2.Remove the top bezel.
See Chapter 13, “Preparing for Service,” for information on removing this assembly.
3.Remove the side vents. Push each side vent backwards until it stops. Then lift the vent off the Enterprise system and set it aside.
4.Remove the top cover.
a.Locate the four plugs in each corner of the enclosure.
b.Lift each plug by pushing down in the dotted area. This action causes the plug to pop up.
c.Remove each plug.
d.Lift up the front of the top cover and slide it backwards approximately
5.Remove all the boards and power supplies.
See Chapters
|