Sun Microsystems 6.0005E+11 manual Removing a Board from a Nonpowered On System, 5CPU/Memory Board

3

3.Pull the ends of both extraction levers outward simultaneously to unseat the board centerplane connector from the centerplane receptacles.

See Figure 3-5 for the positioning of the levers.

Extraction lever in extract/insert position

Figure 3-5CPU/Memory Board

4.If a board is not immediately replaced, a load board (Enterprise 6000 systems only) or a filler panel (Enterprise 4000 and 5000 systems only) must be installed in its place.

See Section 3.2, “Filler Panels and Load Boards.”

3.4.1.2Removing a Board from a Nonpowered On System

1.Use a Phillips #1 screwdriver to mechanically release the board from the system card cage.

Insert the screwdriver into each quarter-turn access slot (the slots are located on the left and right sides of the board front panel) and then turn a quarter turn so that the arrow points to the unlocked position. See Figure 3-4.

3-8 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996