Sun Microsystems 6.0005E+11 manual Place the module in an antistatic bag

3

2.Use a 3/32 Hex driver to loosen all screws on each of the compression connectors on the module to be removed (three screws for the 288 pin connector, two screws for the 144 pin connector).

See Figure 3-9.

3.Lift the module straight up, off the board mating surface and the single standoff that locks the module to the board.

Use pressure applied with fingers to assist in removing module from standoff. See Figure 3-11.

Standoff,

1 per module

Figure 3-11UltraSPARC Module Removal and Replacement

4. Place the module in an antistatic bag.

3-16 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996