Sun Microsystems 6.0005E+11 manual Key Switch Adapter Assembly

E

Caution – DO NOT FORCE the SCSI adapter assembly into the slot; this can

!cause damage to the assembly and system.

The SCSI adapter assembly should insert and seat smoothly. If it binds, remove it, and inspect the slot for any obvious obstructions. Do not damage the springfingers at the bottom of the assembly.

2.Tighten the three captive screws on the bottom that secure the SCSI adapter assembly to the cabinet.

See Figure E-13.

3.Connect the two cable assemblies to the front of the SCSI adapter assembly.

See Figure E-6.

4.Power on the Enterprise system.

See the power on instructions in Chapter 12, “Powering Off and On.”

E.1.7 Key Switch Adapter Assembly

To remove the key switch adapter assembly:

1.Completely power off the Enterprise 6000 system.

See the power off instructions in Chapter 12, “Powering Off and On.”

2.Disconnect the cable assembly from the front of the key switch adapter assembly.

3.Loosen the two captive screws on the bottom that secure the key switch adapter assembly to the cabinet.

4.Pull and slowly remove the key switch adapter assembly from the cabinet.

To replace the key switch adapter assembly:

1.Carefully insert the key switch adapter assembly into the front of the Enterprise 6000 system.

E-20 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996