Sun Microsystems 6.0005E+11 manual Remove the top panel, Remove the panel and set it aside

8

8.1.2Removing/Replacing a Tape or CD-ROM Drive in Enterprise 6000/5000 Systems

To remove and replace an existing device, perform steps 1 through 5. To install a tape device for the first time, proceed to step 6.

Caution – To prevent breakage, do not grasp the panel by the bottom edge.

!

1.Remove the top panel.

Grasp the panel on both sides at the top and pull out far enough to just disengage the ball studs. See Figure 8-4.

2.Remove the panel and set it aside.

Figure 8-4Removing the Top Front Panel

Note – It is not necessary to remove the SCSI tray to replace a device; only the device enclosure needs to be removed.

3.Release the device enclosure from the SCSI tray by removing three screws on the left-hand side as depicted in Figure 8-5.

You will then be able to move the device enclosure forward to release the data and power cables from the rear of each device.

Internal SCSI and Storage Devices 8-5