3
3.5.5.1Removing a Graphics (UPA) Card
1.Use the procedures in Section 3.5.2, “Removing a Board,” to remove the applicable Graphics I/O board.
2.Locate the card. See Figure
3.Remove the two screws that secure the card to the Graphics I/O board front panel.
Save the screws for installation of a replacement card or a filler panel.
4.Unlock the card by pulling up the tips of the two standoffs. See Figure
5.Hold the card by the edges near the connector and gently rock the card back and forth to loosen it from the socket.
You may have to remove the SBus cards next to this card in order to have enough room to hold onto the graphics (UPA) card being removed.
Caution – The connector housing may break if the card is tilted too far.
!
6.Lift the card from the socket at an angle while guiding the face plate out from the back panel opening.
See Figure 3-22.
Ultra Enterprise 6000/5000/4000 Systems |
