Troubleshooting Overview | 9 |
|
| ||
| ||
| ||
| ||
|
|
|
9.1 Using a Terminal
If the system does not have a console, you can log in remotely through the network or attach a terminal directly to the system.
To attach a terminal to the system:
1.Halt the system and turn off power.
2.Connect the terminal to serial port A on the clock board.
The clock board is located at the back of system, above the card cage. Figure
3.Power on the terminal.
4.Set up the terminal.
Refer to the OpenBoot Command Reference for instructions for using the set- defaults and printenv commands.
The settings will vary with the terminal type, but these settings are often used:
•9600 bps
•8 data bits
•1 stop bit
•Even parity
•Full duplex
