3 
3.Hold the card at a slight angle and position it so the fiber connector end is loosely inserted into the I/O board front panel opening.
4.Align the card over the I/O board fiber connector receptacle and over the four standoff holes on the I/O board.
See Figure 3-24 on page 3-33.
5.Seat the card:
a.Grasp the card underneath each corner near where the card connects to the I/O board fiber connector receptacle. Firmly seat the card on the connector and on the two adjacent standoffs.
b.On the end of the card near the I/O board front panel, grasp the card underneath each side and firmly seat the remaining two standoffs.
6.Use the procedures in Section 3.5.3, “Installing a Board,” to replace the I/O board.
I/O Boards and Components |
