TANDBERG MCU 4500, MSE 8510 manual Chair control, Reservation mode

Select the delay to be applied to audio relative to video.

A setting used only to rectify some types of 'lip sync' issues sometimes found with certain endpoints. Leave at default setting, unless advised to alter it by Codian technical support or a reseller.

Controls whether connected endpoints are	This option acts as a unit-wide control over
allowed to use floor and chair control operations.	whether any H.243 floor and chair control
	operations are permitted. Individual conferences
	may have their own floor and chair control
	policies set; however, if this setting is Disabled
	then no floor or chair control operations will be
	possible within conferences. Changing this setting
	will only affect new calls - existing calls will
	continue with the setting in force when they
	became active.
	For more information, refer to H.243 floor and
	chair control.
Sets the default action when endpoints call into	This option can make it easier for callers to create
the MCU using an unknown E.164 number; i.e.	ad hoc conferences if Create new conference is
one the does not correspond to any configured	selected. If you do not wish callers to be able to
conference.	create conferences in this way, select one of the
The endpoint will enter the default auto	other options.
attendant from which they may join
existing conferences or potentially
create a new conference (see Using an
auto attendant). This behavior is the
same as if the endpoint had called the
MCU using its IP address rather than an
E.164 number.
Endpoints are not allowed to call
unknown E.164 numbers, and the call
will be terminated.
A new conference will be created with
the E.164 number called as its numeric
identifier. The endpoint automatically
joins this new conference. This option is
not available if the MCU is in port
reservation mode.
When enabled, if the MCU is calling out to an	Without this option selected, the caller ID is the
H.323 endpoint, the caller ID that the endpoint	name of the MCU.
will see is the conference name.
Instructs the MCU to request conference	You may wish participants joining a conference
participants dialing into protected conferences	via a gatekeeper not to need to enter a PIN, even
using an E.164 number via an H.323 gatekeeper	for protected conferences. If this is the case, do
to enter a PIN before they may join the	not set this option. If you wish conferences to be
	117