TANDBERG MSE 8510, MCU 4500 manual connected, which have disconnected, and reasons

configured endpoint.

Note that if the original call to the conference was from the endpoint rather than the endpoint being invited by the MCU, then for the MCU to recognize it, that endpoint must be configured with Call-in match parameters. If the ** ERROR ** did not recognize that the call was from a pre- configured endpoint then the re-connect control will not be available.

For more information about configuring endpoints on the MCU refer to Configuring H.323 endpoints and Configuring SIP endpoints.

Displays the time at which a participant disconnected from the conference and who initiated the disconnect.

Refer to the table below to get details about pre-configured endpoints.

Indicates whether the participant is an H.323,

SIP, or VNC endpoint.

Displays the name of the endpoint.

Displays the connection status of the pre-	This field shows which participants have
configured participant.	connected, which have disconnected, and reasons
	for failure if a participant has failed to connect to
	the conference.

You may wish to inform participants about conference details such as start time, and so on. Click the icon to display further details about a conference. This information may be copied to the clipboard for

convenience.

Click this icon to watch the conference. This is exactly the same as clicking the link in the Conference list. Both take you to the conference streaming page. See Using streaming to view conferences for more information.

66