TANDBERG MSE 8510, MCU 4500 manual Unknown, To configure monitoring using SNMP, go to

To configure monitoring using SNMP, go to.

The MCU sends out an SNMP trap when the device is shut down or started up. The SMNP page allows you to set

various parameters; when you are satisfied with the settings, click .

Note that:

The 'system up time' that appears in the trap is the time since SNMP was initialized on the MCU (and

therefore will differ from the Up time reported by the MCU on the > page). The SNMP MIBs are read-only.

Identifies the MCU in the SNMP system MIB.	Usually you would give every device a unique
	name. The default setting is:
	Codian MCU

The location that appears in the system MIB.

An optional field. It is useful where you have more than one MCU to identify where the unit is located. The default setting is:

Unknown

The contact details that appear in the system MIB. An optional field. The default setting is: Unknown

	Add the administrator’s email address or name to
	identify who to contact when there is a problem
	with the device. If SNMP is enabled for a port on
	the public network, take care with the details you
	provide here.
A description that appears in the system MIB.	An optional field, by default this will indicate the
	model number of the unit. Can be used to
	provide more information on the MCU.

146