
To configure gatekeeper settings, go to | . |
You can configure the MCU to use a gatekeeper, which can make it easier for
In this section:
Gatekeeper settings
Gatekeeper status
Refer to this table for assistance configuring the gatekeeper settings. After making any configuration changes, click
.
Enables the MCU to use an H.323 gatekeeper for registration of numeric identifiers for its conferences and/or auto attendants.
When set to Disabled then no gatekeeper registrations are attempted (and existing registrations are torn down), regardless of other gatekeeper or
When set to Enabled registrations with the gatekeeper are attempted, and the gatekeeper is contacted for incoming and outgoing calls. If the gatekeeper does not respond, calls are still connected if possible. When set to Required registrations with the gatekeeper are attempted but calls are not connected if the gatekeeper cannot be contacted.
Identifies the network address of the gatekeeper | This can be specified either as a host name or as | |
to which MCU registrations should be made. | an IP address. |
|
| This field will have no effect if H.323 Gatekeeper | |
| usage (see above) is set to Disabled. |
|
| The gatekeeper can be either the | |
| gatekeeper enabled on the | page (see |
| Displaying the | |
| list) or an external gatekeeper. To use the | |
| gatekeeper enter "127.0.0.1". For an external | |
| gatekeeper, enter its host name or IP address. | |
|
| |
Controls how the MCU identifies itself when | Codian recommends that you use the Terminal / | |
registering with its configured gatekeeper. | gateway option unless you are using a service | |
| prefix (in this case, use Gateway). Only use a | |
| different option if you are: |
|
|
|
|
|
| 119 |